Tag Archives: well life cycle

Introduction to Well Integrity

By | |
2 Comments

According to Norsok D-010, well integrity is defined as the “application of technical, operational and organizational solutions to reduce the risk of uncontrolled release of formation fluids and well fluids throughout the life cycle of a well”.

Well Integrity is defined in ISO/TS 16530-2 as: “containment and the prevention of the escape of fluids (i.e. liquids or gases) to subterranean formations or surface”

In API RP 65-2, well integrity is defined as: “a quality or condition of a well being structurally sound with competent pressure seals by application of technical, operational, and organizational solutions that reduce the risk of uncontrolled release of formation fluids throughout the well life cycle “.

Following from the aforementioned definitions of well integrity, the personnel planning the drilling and completion of wells will have to identify the solutions that give safe well life cycle designs that meet the minimum requirements of the standard.

Continue reading →

5 things you should know about the ISO 16530-1 Well Integrity Standard

By | |
Leave a comment

By Mark Plummer MSc BEng, Passionate Drilling Engineer – Oil & Gas | Geothermal | HPHT | Well Abandonment (P&A) | Well Examiner

In March, 2017 ISO released their Latest Well Integrity Standard, ISO 16530-1: Life Cycle Governance. In this article I will provide the background to the standard and discuss some of the key sections contained within.

BACKGROUND TO ISO 16530-1

1. It was developed by producing operating companies for oil and gas, and is intended for use in the petroleum and natural gas industry worldwide

2. It is intended to provide guidance to the Well Operator on managing well integrity throughout the well life cycle. Furthermore, it addresses the minimum compliance requirements for the well operator to claim conformity with ISO 16530-1.

3. It provides recommendations and techniques that well operators can apply in a scalable manner, based on a well’s specific risk characteristics

4. ISO 16530-1 is intended to compliment the 2014 issued ISO 16530-2 Technical Standard (TS) – Well Integrity for the Operational Phase, which is intended to provide the requirements to manage Well Integrity during the operation (production) phase only.

5. The standard is not applicable to:

  • Well control activities implemented to prevent or mitigate unintentional release of formation fluids from the well to its surroundings.
  • Wellbore integrity, sometimes referred to as “borehole stability”

KEY SECTIONS OF ISO 16530-1

Continue reading →